Hybrid eventIn-person & virtual
March 18–20, 2027Singapore · Village Hotel Changi

Talk Details · Materials 2027

Development of nanocellulose-reinforced bioplastic film composite using nanocellulose derived from bamboo Dendrocalamus strictus (Roxb.) Nees.

Oral · In-Person · Day 1

Abstract

About this talk

Male bamboo poles were collected from Diadi, Nueva Viscaya. The poles were processed into bamboo slats while removing the outer skin to about 2”x1” suitable for cooking in an electric digester. A 45.60% pulp yield was obtained after the sulfide pulping of bamboo chips under constant pressure and temperature. Chemical analysis showed an increase in alpha cellulose and the removal of lignin as the bamboo fibers went through the pulping and bleaching process which was also seen in FTIR analysis. The XRD pattern of the raw and bleached bamboo pulp showed the amorphous and crystalline region at 16° and 22° (2θ) respectively.

A white gel material was obtained after 2 hours of TEMPO oxidation of the bamboo bleached pulp. The increase in sodium carbonate increases CNF carboxylate content. Moreover, particle size analysis reveals the reduction of cellulose fibers. High pressure shear homogenization of TEMPO pulp reduced the fiber diameter from 384.1nm into 58.5nm after 3 passes. Conductive titration showed an increase carboxylic content of cellulose of 40.80 mmol/100g and 51.87 mmol/100g as the oxidant was increased from 5mmol/g to 15mmol/g respectively.

A whitish translucent thermoplastic starch film was obtained successfully using 5% starch concentration and heated at 80°C for 10 mins and subsequently dried under the vacuum oven for 3 days. In contrast, a clear bioplastic film was obtained after drying pure nanocellulose via vacuum drying. Incorporating CNF into TPS bioplastic film showed a translucent biofilm. TGA and FTIR scans showed the biocompatibility of cellulose and starch as evident to the similarities in the graphs. XRD analysis showed the combination of starch and CNF profile as CNF was used as reinforcement in TPS film. Lastly, an increase in TPS biofilm mechanical strength can be observed after the incorporation of CNF. The maximum tensile strength was determined using 0.4% CNF with 22.16MPa.

Speaker

About the speaker

Anniver Ryan P Lapuz

Anniver Ryan P Lapuz

Forest Products Research and Development Institute, Philippines

View full speaker profile →

Join the Materials 2027 delegation

Singapore · March 18–20, 2027· Hybrid · in-person & virtual

Register as Delegate →

Attend without presenting.